Intel NetportExpress PRO User Manual page 35

;NI_IRQ = [IRQ VALUE FROM STEP 5 OF THE FIRST PROCEDURE ABOVE]
to read
NI_IRQ = [IRQ VALUE FROM STEP 5 OF THE FIRST PROCEDURE ABOVE]
The NI_IRQ value must be the same as the interrupt value you will
use for the Intel adapter.
6 Run the SETUP program from the PATHWORKS SETUP disk for
LAN Manager.
7a For Pathworks 5.0, choose Configure PC.
7b For Pathworks 6.0, select Yes for the "Has the Pathworks software
been installed to a LAN Manager file Service."
8 In the Select Drive Window, choose "Network."
9 Select DECnet as transport.
10 When prompted to choose a network adapter, choose "Other."
11 When prompted for driver information, in the "Other Adapter"
window use the following:
a. for PATHWORKS 5.0:
NDIS DRIVER PATH: A:\
NDIS DRIVER FILE: M32ANDIS.EXE
NDIS DRIVER NAME: INTEL$
b. for PATHWORKS 5.1:
DRIVER FILE: A:\M32ANDIS.EXE
PROTOCOL.INI STUB: A:\DEC\PROTOCOL.INI
c. for PATHWORKS 6.0:
DRIVER FILE: A:\M32ANDIS.EXE
PROTOCOL.INI STUB: A:\DEC\PROTOCOL.INI
Skip the Additional Files section.
12 Insert the Intel Network Drivers Disk when prompted.
13 Enter your node information when prompted.
14 Save the PROTOCOL.INI file with the default settings.
At this point, the SETUP program will try to connect to the DECnet
server. Once connected, the SETUP program will map a logical drive
to your system service.
Software Installation
29