Intel NetportExpress PRO User Manual page 23

if installing from a Novell NetWare Server you are connected to.
3 Once you have selected the proper path, run SETUP.EXE and follow
the Novell instructions. At the last screen, DO NOT select REBOOT.
Instead, click CUSTOMIZE.
NOTE
If prompted to insert the Windows 95 CD-ROM, click OK and type the path to the
CABS directory on your hard drive (usually C:\WINDOWS\OPTIONS\CABS).
4 The CUSTOMIZE option will take you to the Network dialog box
where you may or may not have an adapter installed. DO NOT
REMOVE any of the existing drivers. First ADD the 32 Bit ODI
driver by selecting Add. Then in the Select Network Adapter Type
box select Adapter. Next, in the Select Network Adapters box click
Have disk and insert the Intel Network Drivers Disk (Disk 2). Select
OK at the Install from Disk box. In the next window highlight Intel in
the manufacturers column and Intel EtherExpress PRO/100 CardBus
Adapter for NetWare Client 32 V1.0.
5 This will take you back to the Network window where you may now
remove the existing driver if there was one. You should be left with a
Novell ODINSUP and an Intel PRO/100 CardBus adapter for
NetWare Client 32 V1.0 adapter.
6 If your laptop requires any special resources, you may select the
adapter and Properties window to change them. Otherwise click OK .
NOTE
If asked to insert the NetWare Client 32 for Windows 95 Disk x click OK and enter
the path to the Client 32 Install from Step 2 above.
7 After rebooting, the driver will load but you may receive a New
Hardware Found PCI Card message which will take you to the Update
Device Driver Wizard window. At this window make sure you DO
NOT have the drivers disk in drive A:. Then click Next >. The next
window should display "Windows was unable to locate a driver for
this device." Now click Finish. You should not see this message in
subsequent reboots. This step will leave a "?!PCI Card" indication in
the Control Panel\System Properties\Device Manager\Other Devices
section, but will not hinder operation of the driver. However, if you
wish to reinstall the Miniport driver at a later time be sure, to remove
the "?!PCI Card" line from the above named window.
Software Installation
17