Cisco Catalyst 2950 Command Reference Manual page 329

Chapter 2 Cisco IOS Commands
•
•
Defaults
VLAN 1 is the default native VLAN ID on the port.
The default for all VLAN lists is to include all VLANs.
Command Modes Interface configuration
Command History Release
12.1(6)EA2
Usage Guidelines
A trunk port cannot be a secure port or a monitor port. However, a static-access port can monitor a VLAN
on a trunk port. The VLAN monitored is the one associated with the static-access port.
Allowed VLAN:
•
•
Native VLANs:
•
•
•
78-11381-05
except lists the VLANs that should be calculated by inverting the defined list of VLANs. (VLANs
are added except the ones specified.) Valid IDs are from 2 to 1001. Separate nonconsecutive VLAN
IDs with a comma; do not enter a space after the comma. Use a hyphen to designate a range of IDs;
do not enter a space before or after the hyphen. Do not enter leading zeros.
vlan-atom is either a single VLAN number from 1 to 4094 when the EI is installed and 1 to 1005
when the SI is installed, a list of nonconsecutive VLANs, or a continuous range of VLANs described
by two VLAN numbers, the lower one first, separated by a hyphen.
For a list of nonconsecutive VLAN IDs, separate the VLAN IDs with a comma. Do not enter a space
after the comma. Do not enter leading zeroes.
For a continuous range of VLAN IDs, use a hyphen to designate the range. Do not enter a space
before or after the hyphen. Do not enter leading zeroes.
These are examples showing how to specify one or more VLANs:
Single VLAN—101
–
List of nonconsecutive VLANs—10,12,14,16,18
–
Continuous range of VLANs—10-15
–
– List of VLAN continuous ranges—10-15,20-24
– List of nonconsecutive VLANs and VLAN continuous ranges—8,11,20-24,44
Modification
This command was first introduced.
The no form of the allowed vlan command resets the list to the default list, which allows all VLANs.
You cannot remove VLAN 1 or VLANs 1002 to 1005 from the allowed VLAN list.
All untagged traffic received on an 802.1Q trunk port is forwarded with the native VLAN configured
for the port.
If a packet has a VLAN ID that is the same as the sending port native VLAN ID, the packet is sent
without a tag; otherwise, the switch sends the packet with a tag.
The no form of the native vlan command resets the native mode VLAN to the appropriate default
VLAN for the device.
Catalyst 2950 Desktop Switch Command Reference
switchport trunk
2-305