Cisco Catalyst 2950 Command Reference Manual page 129

Chapter 2 Cisco IOS Commands
This example shows how to delete the previously configured ten IP multicast addresses:
Switch(config)# no mvr group 228.1.23.1 10
This example shows how to delete all previously configured IP multicast addresses:
Switch(config)# no mvr group
This example shows how to set the maximum query response time as 1 second (10 tenths):
Switch(config)# mvr querytime 10
This example shows how to return the maximum query response time to the default setting of one-half
second:
Switch(config)# no mvr querytime
This example shows how to set VLAN 2 as the multicast VLAN:
Switch(config)# mvr vlan 2
Use the show mvr members privileged EXEC command to display the IP multicast group addresses
configured on the switch.
You can verify your settings by entering the show mvr privileged EXEC command.
Related Commands Command
mvr immediate
mvr type
mvr vlan group
show mvr
show mvr interface
show mvr interface
show mvr members
78-11381-05
Description
Enables the Immediate-Leave feature on an interface.
Configures a port as a receiver or source port.
Configures a receiver port as a member of an MVR group.
Displays MVR global parameters or port parameters.
Displays the configured MVR interfaces with their type,
status, and Immediate-Leave configuration.
interface-id member Displays all MVR groups of which the interface is a
member.
Displays all ports that are members of an MVR multicast
group; if the group has no members, its status is shown as
Inactive.
Catalyst 2950 Desktop Switch Command Reference
mvr
2-105