Show Ip Igmp Snooping Mrouter - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Cisco IOS Commands

show ip igmp snooping mrouter

Use the show ip igmp snooping mrouter privileged EXEC command to display information on
dynamically learned and manually configured multicast router ports.
Syntax Description
vlan vlan-id
| begin
| exclude
| include
expression
Command Modes Privileged EXEC
Command History Release
12.0(5.2)WC(1)
Usage Guidelines You can also use the show mac address-table multicast command to display entries in the MAC
address table for a VLAN that has Internet Group Management Protocol (IGMP) snooping enabled.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show ip igmp snooping mrouter vlan 1 command:
Note In this example,
Switch# show ip igmp snooping mrouter vlan 1
Vlan
----
1
78-11381-05
show ip igmp snooping mrouter [vlan vlan-id] [ | {begin | exclude | include} expression]
(Optional) Keyword and variable to specify a VLAN; valid values are 1 to
4094 when the enhanced software image (EI) is installed and 1 to 1001
when the standard software image (SI) is installed. Do not enter leading
zeros.
(Optional) Display begins with the line that matches the specified
expression.
(Optional) Display excludes lines that match the specified expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was first introduced.
is a dynamically learned router port, and
Fa0/3
ports
-----
Fa0/2(static), Fa0/3(dynamic)
show ip igmp snooping mrouter
is a configured static router port.
Fa0/2
Catalyst 2950 Desktop Switch Command Reference
2-171