Cisco Catalyst 2950 Command Reference Manual page 260

snmp-server enable traps
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
Use the snmp-server enable traps command to enable sending of traps or informs, when supported.
Note Informs are not supported in SNMPv1.
To enable more than one type of trap, you must issue a separate snmp-server enable traps command
for each trap type.
Examples
This example shows how to send VTP traps to the NMS:
Switch(config)# snmp-server enable traps vtp
You can verify your setting by entering the show vtp status privileged EXEC or the show
running-config privileged EXEC command.
Related Commands Command
show running-config
snmp-server host
Catalyst 2950 Desktop Switch Command Reference
2-236
Description
Displays the running configuration on the switch. For syntax information,
select Cisco IOS Configuration Fundamentals Command Reference for
Release 12.1 > Cisco IOS File Management Commands > Configuration
File Commands.
Specifies the host that receives SNMP traps.
Chapter 2 Cisco IOS Commands
78-11381-05