Cisco Catalyst 2950 Command Reference Manual page 57

Chapter 2 Cisco IOS Commands
This example shows the error message when this command is entered on a member switch:
Switch(config)# cluster standby-group my_hsrp
%ERROR:This command runs on a cluster command switch
You can verify your settings by entering the show cluster privileged EXEC command.
Related Commands Command
show cluster
show standby
standby ip
78-11381-05
Description
Displays the cluster status and a summary of the cluster to which the switch
belongs.
Displays standby group information.
Enables HSRP on the interface.
Catalyst 2950 Desktop Switch Command Reference
cluster standby-group
2-33