Tainet T-288C User Manual page 89

5-2
Cmd
Xn X0:return 0-4 result codes;no dial,busy tone detect
X1:return 0-5,10-39 result codes;no dial,busy tone detect
X2:return 0-6,10-39 result codes;no busy tone detect
X3:return 0-5,7,10-39 result codes;no dial tone detect
X4:return all(0-39) result codes;dial,busy tone detect
Yn long space disconnect 0:no
Zn reset modem & recalls user profile n , n=0-9
&Cn DCD control 0:forced on 1:normal 2:V.13 HDX
&Dn DTR control 0:forced on 1:DTR off enter command mode
&Fn recall factory default profile n, n=0-9
&Gn guard tone control 0:disabled 1:550Hz 2:1800Hz
&Ln line type control 0:dial line 1:2w L-L 2:4w L-L
&Mn direct mode data format 0:Async 1:Sync
&Qn async/sync mode 0:async 1:async command/sync data
2:sync mode,DTR on auto dial 3:sync mode,manual dial
&Rn RTS control 0:normal 1:forced on
&Sn DSR control 0:forced on 1:on in data mode
&Tn 0:end test
2:reserved
4:remote digital loopback grant on
5:remote digital loopback grant off
6:remote digital loopback test (RDL)
7:remote digital loopback pattern test (RDL+TP)
8:local analog loopback pattern test (AL+TP)
9:reserved
10:test pattern generator & detector (TP)
&Vn display user profile n, n=0-9
&Wn write active configuation to User Profile n, n=0-9
Table 5-1: AT Command Set (cont.)
Function Description
1:yes
3:pseudo HDX
2:DTR off disconnect 3:DTR off reset modem
1:local analog loopback test (LAL)
3:local digital loopback test (DL)
INSTRUCTION SETS