Tainet T-288C User Manual page 59

3-34
ç
NORMAL
ç
AUTO DIAL/ANS
DTR OFF ACTION
ç
FORCE ON
ç
COMMAND MODE
ç
DISCONNECT
ç
MODEM RESET
DSR CONTROL
ç
NORMAL
ç
FORCED ON
DCD CONTROL
ç
FORCE ON
ç
NORMAL
ç
V.13 HDX
ç
PSEUDO HDX
RTS CONTROL
ç
NORMAL
ç
FORCED ON
RTS/CTS DELAY
ç
0..2550 ms
AT%D0 /Same as V.25 108.2 DTR operation (default).
AT%D1 /Same as V.25/V.25bis 108.1 DTR operation.
When DTR is from OFF to ON,the modems will
dial ( see DIAL MENU-AUTO dial tel# ) and
answer ( Note the ring times in dial manu must be
set to AUTO ANS OFF).
AT&Dn On originate and answer site respectively modem
action select for DTR from ON to OFF.
AT&D0 /Force DTR in ON position (default).
A power-on auto dial operation can be achieved
when operating with DTR ON auto dial.
AT&D1 /Return to command mode.
AT&D2 /Disconnect. Normally used with 108.1.
AT&D3 /For Modem reset.
AT&Sn DSR signal control selection.
AT&S1 /DSR ON after Modem handshaking.
AT&S0 /Force DSR in ON position.
AT&Cn DCD signal control selection.
AT&C0 /Forece DCD in ON position.
AT&C1 /DCD ON means line is in connection while DCD
OFF means line is OFF.
AT&C2 /CCITT V.13 standard simulated carrier in half-
duplex.
AT&C3 /When data continuously receive all one's more
than 24 bits or when line is disconnected, drop
DCD to operate as simulated HDX control
carrier.This is normally used in IBM SNA Polling
networks.
AT&Rn RTS signal control selection.
AT&R0 /Controlled by DTE.
AT&R1 /Keep RTS in ON position.
ATS26=n Delay time from RTS-ON to CTS-ON. Usually
used in cascade application (default=0).
(bit0..7) /0-2.5 seconds.
FRONT PANEL LCD AND MENU-DRIVEN