Tainet T-288C User Manual page 58

FRONT PANEL LCD AND MENU-DRIVEN
3.5.7 CONFIG DTE MENU
ITEM NAME
DTE SPEED
ç
300bps
ç
600bps
ç
1200bps
ç
1800bps
ç
2400bps
ç
3600bps
ç
4800bps
ç
7200bps
ç
9600bps
ç
12000bps
ç
14400bps
ç
16800bps
ç
19200bps
ç
21600bps
ç
24000bps
ç
26400bps
ç
28800bps
ç
31200bps
ç
33600bps
ç
38400bps
ç
57600bps
ç
76800bps
ç
115200bps
FLOW CONTROL
ç
OFF
ç
X-ON, X-OFF
ç
RTS/CTS
ç
CTS ONLY
DTR CTL 108
COMMAND
ATxxxxx This setting is used to determine DTE speed when
auto speed conversion is ON in V.42 / MNP /
("xxxxx" =
normal mode.
DTE Speed)
*When using direct mode and all the synchronous
modes, this setting will not available and DTE
speed will be determined by modem speed, DTE
speed = modem speed.
*The throughput is improved by using data
compression,enhance this set higher than the
modem speed is suggested to enable more
effective operation.
*When use "AT" command and auto baud rate
detect function"ON",this setting will be replaced
by identified speed.
*Auto baud rate detect function can be offered
up to 38400 bps only. (115.2k for new version T-
288C/NC)
/Default = 9600 bps.
AT\Qn Used to set flow control between terminal and
modem when using V.42/MNP and normal mode
(asynchronous mode only).
*Another ENQ/ACK control can be used with one
of the following (see PROTOCOL MENU) for
control code in HP network.
AT\Q0 /No flow control (default).
AT\Q1 /Software control, used in text data.
AT\Q2 /Hardware control, bilateral, accept any type of
data.
AT\Q3 /Hardware
control, but modem send the data in spite of RTS
from DTE, unilateral control.
AT%Dn Modem action select for DTR from OFF to ON.
DESCRIPTION
control identical to RTS/CTS
3-33