Table of Contents
Advertisement
FRONT PANEL LCD AND MENU-DRIVEN
SEND ADP./ODP.
ç
OFF
ç
ON
SIM. ENQ.
ç
NONE
ç
SIM. PERIPHRAL
ç
SIM. HOST
DISCON. METHOD
ç
IMMEDIATE
ç
WITH CLEAR-DOWN
DCD-DCE FLOW
ç
OFF
ç
ON
DCE INACTIVE
ç
FOREVER
ç
1..7 MINUTES
RESEND TIMES
ç
FOREVER
ç
12..180 TIMES
FAST RESET
ç
NORMAL ATZ,AT&F
ç
FAST ATZ
ç
FAST AT&F
ç
FAST ATZ,AT&F
ATS40=n
During
identification,a special fixed signal will be
(bit3)
identified if V.42 protocol can be provided. But
if the user be sure that the modem of both sides
use or not use V.42, he may set to OFF so as to
speed up the line connection. (default is ON).
AT\Hn
Emulate ENQ/ACK in DTE pacing, normally
used
terminals. This function can be used together with
DTE flow control or used alone.
AT\H0
/(default).
AT\H1
/Use in connection with HP Host.
AT\H2
/Used in connection with HP terminal.
ATS40=n
Disconnect method for V.32/V.32bis/V.34.
(bit2)
/Immediate disconnect.
/Send clear down before disconnection.
AT\Gn
To activate DCE-DCE flow control or not in
normal mode.
AT\G0
/Disable. Normally, DCE-DCE flow control is
not necessary unless DTE speed < modem speed
(default).
AT\G1
/Enable.
ATS43=n
Under V.42/MNP operation, if the dataflow is
interrupted by any reason caused by DCE with
(bit2...0)
duration
modem will give up V.42/MNP and return to
direct mode.(default = 1 minute).
ATS42=n
For a single block, modem will give up
V.42/MNP and retrun to direct mode when
(bit3...0)
resending times is more than this setting caused
by any reasons. (default = forever).
ATS32=n
Reset rate selection for ATZ and AT&F
(bit0,1)
/(default)
the
process
of
for
the
connection of HP Host and
longer
than
this set time period,
3-21
V.42
protocol
Hide quick links:
Advertisement
Chapters
Table of Contents
