Tainet T-288C User Manual page 43

3-18
PROGRESS TONE
ç
BASIC CODE
ç
DON'T CARE
ç
DIAL TONE
ç
BUSY TONE
ç
DIAL + BUSY TONE
AUTO DIAL TEL#
ç
#0...#9
REDIAL DELAY
ç
IMMEDIATELY
ç
1...255 MINUTES
REDIAL TIMES
ç
DISABLE REDIAL
ç
1..255 TIMES
DIAL TYPE
ç
PULSE
ç
TONE
108.1 ACTION
ç
FIXED ANS/ORG
ç
AUTO BY RING
LOGIN CHECK
ç
OFF
ç
BY MODEM
ç
BY NMS
SHORT ANS TONE
ATXn Select if detect of busy tone or dial tone to
proceed dialing.
ATX0 /Don't care any tone and do not
connection speed.
ATX1 /Don't care busy tone and show line connection
speed.
ATX2 /Don't care busy tone and show line connection
speed.
ATX3 /Don't care dial tone and show line connection
speed.
ATX4 /Do care dial tone, busy tone and extended result
code (default).
ATS51=n Select telephone number in DTR-ON auto dial
mode (CCITT 108.1).
(bit 3....0)
ATS44=n Pause time between auto redial.
ATS44=0 *This setting is limited to more than 3 minutues in
Taiwan and some other countries.
/default=1 minute.
ATS38=n Set times of redial.
ATS38=0 /Disable auto redial function.
/255 times means to proceed redial until line is
successfully connected.
Select dial type.
ATP /Pulse dial (default).
ATT /Tone (DTMF) dial.
Select 108.1 action type.
/Fixed ANS/ORG (default).
/Auto By Ring
Select call in security check function for dial-line
application.
/Login check disable (default).
/Login check by the presented telephone number
stored on the modem device (#0 ~ #9).
/Login check by the Tainet Manager System.
FRONT PANEL LCD AND MENU-DRIVEN
show line