Tainet T-288C User Manual page 56

FRONT PANEL LCD AND MENU-DRIVEN
REMOTE GRANT
ç
OFF
ç
ON
SPK. MONITOR
ç
RX
ç
RX+TX
CTRL CARRIER
ç
OFF
ç ON
JITTER FILTER
ç
50Hz
ç
60Hz
AUTO FB/FF
ç
ON
ç
OFF
SECONDARY CH.
ç
ON
ç
OFF
ATS24=n Set if accept remote control or not.
(bit6) /Not accept.
/Accept(default) *RDL must also be set to ON to
accomplish the remote control function.
ATS41=n Speaker monitor selection.
(bit5) /Monitor RX signal (default).
/Monitor both RX & TX signal.
AST21=n Control carrier selection.
(bit7) /Disable (default).
/Enable
ATS29=n 50/100/150 or 60/120/180Hz jitter filter selection
(for T-288C and ITM-3296bis only)
(bit0) /Enable 50/100/150Hz jitter filter
/Enable 60/120/180Hz jitter filter(default)
ATS24=n The modem continuously monitors the S/N ratio
of the telephone line, then fallback or fall forward
data rate automatically when the S/N ratio lower
or higher than retrain threshold value.
(bit4) /Enable.
/Disable (default).
ATS29=n A secondary channel is provided in high speed
and V.34/V.32bis/V.32 modes, at data rate of
28.8kbps, 19.2kbps, 14.4kbps, 9.6kbps and
4.8kbps. The data rate of this secondary channel is
300bps, full duplex. The data format is
asynchronous only, with 8 data bits, no parity, one
start bit and one stop bit. After change this option,
you shall re-connect the communication channel
to enable your setting.
(bit4) /Enable.
/Disable (default).
3-31