Tainet T-288C User Manual page 123

A3-2
A3.1 Command Summary
All of these commands, except +FTS and +FRS, must be the last command on the
command line. The commands are:
Command
+FTS=<Time>
+FRS=<Time>
+FTM=<MOD>
+FRM=<MOD>
+FTH=<MOD>
+FRH=<MOD>
The MOD parameter may take on the following values:
Value Modulation & Speed
3 V.21 ch.2
24 V.27 ter
48 V.27 ter
72 V.29
96 V.29
A3.2 Capabilities Identification and Control
A3.2.1 Service Class Indication, +FCLASS?
The current Service Class setting of a facsimile DCE is interrogated by the
"+FCLASS?" command. The information text response is a single value:
0 indicates a data modem
1 indicates a Service Class 1 facsimile DCE
other values are reserved
A3.2.2 Service Class Capabilities, +FCLASS=?
The Service Classes available from a facsimile DCE are probed by the "FCLASS=?"
command. The information text response is a list of values, separated by commas. For
example, a DCE that supported data communication and facsimile Service Class 1
would respond: "0,1".
A3.2.3 Service Class Selection, +FCLASS=<value>
The Service Class may be set by the DTE from the choices available (see above) ,
using the "+FCLASS=<value>" command. To configure a DCE for Service Class 1,
the DTE issues the command: "AT+FCLASS=1".
AUXILIARY SUMMARY FOR FAX FUNCTION
Description
Stop transmission and pause,(10 ms intervals 0-255)
Wait for silence,(10 ms intervals 0-255)
Transmit data with <MOD> carrier
Receive data with <MOD> carrier
Transmit HDLC data with <MOD> carrier
Receive HDLC data with <MOD> carrier
300
2400
4800
7200
9600