Tainet T-288C User Manual page 124

AUXILIARY SUMMARY FOR FAX FUNCTION A3-3
A3.3 Service Class 1 Action Commands
A3.3.1 Stop Transmission and Wait, +FTS=<Time>
The command +FTS=<Time> causes the DCE to stop any transmission. The DCE
then waits for the specified amount of time, and then sends the OK result code to the
DTE . The value <Time> is in 10 millisecond intervals.
A3.3.2 Receive Silence, +FRS=<Time>
The command +FRS=<Time> causes the DCE to listen, and to report back an OK
result code when silence has been present on the line for the amount of time specified.
The value <Time> is in 10 millisecond intervals. The command will terminate when
the required amount of silence on the line is detected or the DTE sends the DCE
another character, which is discarded. In either event, the OK result code will be
returned to the DTE.
A3.3.3 Facsimile Transmit, +FTM=<MOD>
The command +FTM=<MOD> causes the DCE to transmit data using the modulation
selected in <MOD>. <MOD> may have the values shown in section 1.1.
The DCE returns the CONNECT result code and transmits the proper training
sequence in the selected mode, followed by constant 1 bits, until data is received from
the DTE.
The DCE buffers data in this mode. The configured flow control method will be used
by the DCE as necessary to pause the DTE.
If the DCEs transmit buffer becomes empty and the last transmitted character is ASCII
NUL (00), the DCE shall continue to transmit NULs until the DTE sends more data or
5 seconds elapses. After 5 second elapse with an empty transmit buffer, the DCE will
turn off transmit carrier and return to command state, returning the ERROR result
code.
NOTE: 00 replication is useful for generating TCF (1.5 seconds of 0s) and zero-fill
within lines.
When the DCEs transmit buffer becomes empty and the last transmitted character was
not NUL, the DCE shall turn off transmit carrier, return to command state and send
the OK result code to the DTE.
A3.3.4 Facsimile Receive, +FRM=<MOD>
The command +FRM=<MOD> causes the DCE to enter receive mode using the
modulation specified in <MOD>. <MOD> may have the values shown in section 1.1.
When the selected carrier is detected, the DCE will send the CONNECT result code to
the DTE.