Tainet T-288C User Manual page 88

INSTRUCTION SETS
CHAPTER 5 INSTRUCTION SETS
5.1 AT Command Set
Cmd
A enter answer mode
A/ repeat previous command
P originate mode for pulse dialing
T originate mode for tone dialing
D originate mode for dialing
DSn dial stored phone number n = 0-9
En command echo 0:no 1:yes
Hn 0:on hook 1:off hook
In display 0:product code 1:checksum 2:verify value
Ln speaker volume 0,1:low 2:medium 3:high
Mn speaker control 0:always off 1:on until DCD is detected 3:off
during dialing,on until DCD is detected
Nn DCE speed follow 0:DTE speed 1:by link
On 0:return to data mode 1:return to data mode and initiate retrain
Qn send result code 0:yes 1:no
Sn? read s-register n=s-reggster number
Sn=x modify s-register n value to x
Vn result code 0:short form (digits)1:long form (words)
Wn long form result code 0:standard 1:extend1 2:extend2
Table 5-1: AT Command Set
Function Description
5-1