Call Channel Programming - Icom iC-M91D Instruction Manual

5
BASIC OPERATION
D Channel group selection
There are preprogrammed international channels for the IC-
M91D. For U.K. transceiver version, there are preprogrammed
U.S.A. channels in addition to International channels. For
Dutch and German versions, there are preprogrammed ATIS
and DSC* channels in addition to International channels.
Except for the Europe version, a channel group suitable for
your operating area is selectable, as described below.
Push [MENU].
q
Push [ Y]/[Z] to select "Radio Settings".
w
Y]/[Z] to select "CHAN Group", and then push [EN-
Push [
e
TER].
r Push [Y]/[Z] to select the desired channel group, and then
push [ENTER].
t Push [EXIT] to exit the Menu screen.
Push [Y](CH)/[Z](CH) to select a channel.
y
• "DUP" appears for duplex channels.
• "A" appears for simplex channel.
* German version only.
13
When the U.S.A. channel group is
selected.

Call channel programming

■
You can program the call channel with your most often-used
channels in each channel group for quick recall.
Select the desired channel group to be programmed, as
q
described to the left.
Hold down [16/C] for 1 second to select the call channel of
w
the selected channel group.
• "CALL" and call channel number are displayed.
Hold down [16/C] again for 3 seconds until long beep stops
e
with two short beeps.
• The channel programming mode screen is displayed.
r Push [Y](CH)/[Z](CH) to select the desired channel.
t Push [ENTER] to program the selected channel as the call
channel.
• The display automatically returns to the normal operating mode.