Atis Code Programming; Preparation - Icom iC-M91D Instruction Manual

4

PREPARATION

ATIS code programming

■
The 10 digit ATIS (Automatic Transmitter Identification Sys-
tem) code can be programmed at power ON.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your ATIS code has already been pro-
grammed, this programming is not necessary.
After programming the MMSI code, "Push [ENTER] to
q
Register Your ATIS" is displayed.
Push [ENTER] to start the ATIS code programming.
w
• Push [CLEAR] twice to cancel the programming, and go to the
normal operating mode. In this case, the ATIS function is dis-
abled. To program the ATIS code, turn OFF the power, then
turn it ON again.
Enter your ATIS code in the following manner:
e
• Select a desired number using [∫]/[√]/[Ω]/[≈].
• Push [ENTER] to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENTER].
11
(For Dutch and German versions)
Repeat step
r
After entering the 10 digit code, "FINISH" is automatically
t
selected, and then push [ENTER] to set it.
The "ATIS CONFIRMATION" screen is displayed.
y
Enter your ATIS code again for confirmation.
u
• Enter in the same manner as steps e through t.
When your ATIS code programming is successfully com-
i
pleted, the screen as shown below is briefly displayed.
• After that, the normal operating screen is displayed.
The programmed ATIS code can be checked in the MENU
screen. (p. 77)
e to enter all 10 digits.