Sound Board; Led Status Board And Ir Board; 10X Cd-Rom Reader And Heat Shield - NEC Versa 2600 Series Service Manual

SOLD BY laptopia2005 DO NOT RESELL!!
4-14 Field Service Guidelines

Sound Board

Remove the Sound Board as follows:

LED Status Board and IR Board

Remove the LED Statue Board and IR Board as follows:

10X CD-ROM Reader and Heat Shield

Remove the CD-ROM reader as follows:
Remove the VersaGlide by inserting a flat head screwdriver into the openings lo-
3.
cated at each rear corner.
 Press down on the retaining tabs and slide the VersaGlide forward as far a
possible
 hold the switch on the front of the VersaGlide in position when removing
VersaGlide.
 lift up on the back edge of the VersaGlide and now move towards the rear
and remove.
T
Locate the sound board. The sound board rests right above the battery bay.
T
Disconnect the ribbon cable from CN405 on the Sound Board and if the
VersaGlide cables are connected to CN406 and CN407, disconnect at this
time.
T
Remove the two screws at the back edge of the sound board .
T
Lift the Sound Board to remove.
T
Disconnect cable at CN20 on the Main Board.
T
Each of these boards are attached by two screws, remove screws
 lift off the LED status board
 for the IR board gently spread the LED bracket and the base assembly
apart at the IR board, slide the IR Board to the right and out.
1. Perform all of the disassembly procedures described in this section, removing the
Keyboard, and LCD subassembly.
NOTE
It is not necessary to remove the
VersaGlide, LED Status Board or IR Board to
gain access to the CD-ROM Reader.
SOLD BY laptopia2005 DO NOT RESELL!!