Powering On The System - NEC Versa 2600 Series Service Manual

SOLD BY laptopia2005 DO NOT RESELL!!
2-2 Setup and Operation
Plug one end of the AC power cable into the AC adapter and the other end into a
3.
properly grounded 120- or 240-volt wall outlet.
NOTE
Do not cover or place objects on the AC
adapter. This will allow heat to dissipate
properly.
4. Ensure that all connections are properly seated and secure.
This equipment uses an ungrounded power cable. Replace the cord if it be-
comes damaged. U.S. and Canadian replacement cords must be UL-
approved (CSA certified in Canada) type SPT-2, 18 AWG, 2-conductor cord
with a permanently attached NEMA type 5-15P plug at one end, and a per-
manently attached connector body on the other. Cord length may not ex-
ceed 15 feet. Outside the U.S. and Canada the cord must be rated for at
least 250VAC at 10 amps, and must indicate international safety agency
approval. The plug must be a type appropriate for the country where it is
used.
Obtain replacement cords at an authorized service center. The replacement
must be of the same type and voltage rating as the original cord.
5. Press the Power button to power on the computer.
Power
Button
Speaker
Microphone
Battery Bay
Figure 2-2
SOLD BY laptopia2005 DO NOT RESELL!!
!
CAUTION
LCD Panel
LCD Slide Bar
Status
LEDs
VersaGlide
NEC
Speaker
Hard Drive
CD-ROM Reader Diskette Drive

Powering On the System