Power Management Settings; Using Fn-F3; Automatic Power-Saving Features - NEC Versa 2600 Series Service Manual

SOLD BY laptopia2005 DO NOT RESELL!!
2-26

Power Management Settings

The system is shipped with many power-saving features already enabled. You can change
the timeout period for these devices in Setup, under the "Power" menu, with the "User Set-
ting Battery" and the "User Setting AC" parameters. The following table lists the default
settings for "User Setting Battery" operation.
DEVICE
Video Timeout
Hard Disk Timeout
CPU Throttle
Standby Timeout
Suspend Timeout
Lid Close

Using Fn-F3

Press the
display modes when an external monitor is connected.
Setup and Operation
To end Suspend mode and return to Active mode, press the Power button on the
hinge beneath the LCD panel and restart the system.
You can set your system to enter Standby or Suspend modes automatically after a
specified number of minutes of system inactivity. System activity includes key-
board, VersaGlide, diskette or hard disk drive access, PC Card modem, network,
or LAN card, serial, or printer port communications.
Table 2-7 Automatic Power-Saving Features
DEFAULT
TIMEOUT
2 minutes
15 Seconds
Good Performance
2 minutes
12 Minutes
Suspend
NOTE
In Windows 95 systems, power man-
agement settings under Windows override the
settings established in Setup. Make the Windows
95 power saving settings match those in Setup
for the best results.
key combination to cycle through LCD only, CRT only, and simultaneous
Fn-F3
SOLD BY laptopia2005 DO NOT RESELL!!
COMMENT
Shuts off video screen after the timeout specified
elapses.
Stops the hard disk motor when the hard disk is
not accessed for the specified timeout.
CPU "clocks down" to slower speeds.
Specifies when the system enters Standby mode
after total system inactivity.
This setting specifies how long the system
remains in Standby mode before entering
Suspend mode.
This setting determines what power-saving action
occurs when the notebook cover is closed while
the system is on.