Diskette Drive - NEC Versa 2600 Series Service Manual

SOLD BY laptopia2005 DO NOT RESELL!!

Diskette Drive

Remove the Diskette Drive as follows.
Figure 4-13 Removing the Bridge Battery and FDD/HDD Connector Board
To remove the FDD/HDD connector board,
3.
T
remove two screws followed by the retaining bracket
T
remove two stand offs
T
disengage the FDD/HDD board from the Main board.
T
Remove the two stand offs
T
Disconnect the ribbon cable at connector CN19 on the Main Board
T
Remove four screws (two from each side of the battery bay housing and
diskette assembly)
T
Remove and save the tape (die cut) that covers the bottom jointing edge of
the hard drive bay and the chassis assembly
T
Lift the Diskette Drive out of the chassis assembly
T
Remove the Diskette Drive from the assembly by removing four screws
SOLD BY laptopia2005 DO NOT RESELL!!
Field Service Guidelines 4-17