Lcd And Top Cover; Removing The Bottom Base Screws - NEC VERSA 6060 Service Manual

4-10 Field Service Guidelines

LCD and Top Cover

Remove the LCD and top cover as follows.
1. Power off the computer.
Remove the bottom base unit cover as follows.
2.
T
Turn the computer over with the VersaBay II slot facing towards you.
T
Locate the 10 screws that secure the bottom base unit cover. In all, there are 2
long-type screws (left side near I/O ports), 2 medium-type screws right side
near I/O ports), and 6 short-type screws.
T
Remove the ten screws.
T
Using a flat-head screwdriver, carefully detach the bottom base unit cover
from the top cover.
T
To lift off the top cover, place your left hand in the PC cards slot bay, and pull
the left corner of the system upward with your right hand. Be careful not to
lift the cover up too far until you have disconnected the LCD cables (see next
step.)
Figure 4-7 Removing the Bottom Base Screws