Power Management Settings - NEC VERSA 2600 User Manual

Power Management Settings

The system arrives set up with many power-saving features
already enabled. You can change the timeout period for
these devices in Setup, under the "Power" menu, with the
"User Setting Battery" and the "User Setting AC" parame-
ters. The following table lists the default settings for "User
Setting Battery" operation.
Automatic Power-Saving Features
DEVICE
Video Timeout
Hard Disk Timeout
CPU Throttle
Standby Timeout
Suspend Timeout
Lid Close
3-14 Using Setup and Power Management
You can set your system to enter Standby or Suspend
modes automatically after a specified number of minutes
of system inactivity. System activity includes keyboard,
VersaGlide, diskette or hard disk drive access, PC Card
modem, network, or LAN card, serial, or printer port
communications.
DEFAULT
COMMENT
TIMEOUT
2 minutes Shuts off video screen after the timeout
specified elapses.
15 Seconds Stops the hard disk motor when the hard
disk is not accessed for the specified
timeout.
Good CPU "clocks down" to slower speeds.
Performance
2 minutes Specifies when the system enters
Standby mode after total system
inactivity.
12 Minutes This setting specifies how long the
system remains in Standby mode before
entering Suspend mode.
Suspend This setting determines what power-
saving action occurs when the notebook
cover is closed while the system is on.