Interface - Motorola RFS Series Reference Manual

5-44 Motorola RF Switch CLI Reference Guide

5.1.14 interface

Global Configuration Commands
Configures a selected interface
This command is used to enter the interface configuration mode for the specified physical
Switch Virtual Interface (SVI) interface. If the VLANx (SVI) interface does not exist, it is
automatically created.
Supported in the following platforms:
• RFS7000
• RFS6000
Syntax (RFS7000)
interface [<interface-name>|ge <1-4>|me1|sa <1-4>|
vlan <1-4094>]
Syntax (RFS6000)
interface [<interface-name>|ge <1-8>|me1|up1|vlan <1-4094>]
Parameters
<interface-name>
ge <1-8>
SWITCH NOTE: The interfaces mentioned below are
supported in the following platforms:
• ge <index> – RFS7000 supports 4 GE's and RFS6000 supports 8 GE's
• sa <1-4> – Only supported with RFS7000
• me1 – Only supported with RFS7000 and RFS6000
• up1 – Only supported with RFS6000
NOTE: The interface mode leads to the
information, see Interface Instance on page
from
RFSwitch(config) #
The name of the interface that is selected.
Gigabit Ethernet interface (4 for RFS7000 and
8 for RFS6000)
config-if
12-1. The prompt changes
to
RFSwitch(config-if)
instance. For more