Converting An Ap To Sensor - Motorola RFS Series Reference Manual

20-32 Motorola RF Switch CLI Reference Guide
Example
RFSwitch(config-wireless)#convert-ap 1 default

20.1.18.1 Converting an AP to Sensor

To convert an AP300 to a sensor:
1. Use
sensor
RFSwitch(config-wireless)#sensor default-config ?
ip-mode
wips-server-ip specify IP addresses of the WIPS server
Select either
2. Specify the VLAN over which the sensors are available. This will help the switch detect
them.
RFSwitch(config-wireless)#sensor vlan 10
3. Use
convert-ap
switch.
RFSwitch(config-wireless)#convert-ap 1 sensor
command to setup the sensor.
configure the IP address mode of the sensors
or
ip-mode wips-server-ip
command to convert the selected AP into a sensor directly from the
NOTE: To convert multiple APs' to Sensor, do it one by one and do
config modifications.
as the sensor parameter.