Motorola RFS Series Reference Manual page 752

20-74 Motorola RF Switch CLI Reference Guide
nas-id <ID>
nas-port-id <ID>
on-channel-scan
radio-number <0-2>
reset
reset-ap
rf-function wips
rf-mode [a|an|b|bg|bgn|
custom|g|n]
rss enable
rts-threshold <0-2347>
run-acs
self-heal-offset <0-30>
short-gi enable
Configures a NAS ID for this radio. <ID> can be up to 256
characters long.
Configures a NAS port id for this radio. <ID> can be up to
256 characters long.
Enables rogue scanning on this radio.
Enter the radio number only if there are two similar radios
on the AP. Enter 0 (zero) or omit when there is no ambiguity.
Resets a radio (this will only reset the specified radio, not
the complete access port).
Resets the parent AP (this will reset all radios on that
access port).
Selects the rf-function for the selected radio.
• wips – Selects WIPS sensor mode.
Selects the radio speed based on the radio mode selected.
Remote Site Survivability (RSS) enables the delivery of
secure uninterrupted wireless service in remote locations in
the event of a device failure.
Defines the RTS threshold in bytes.
Runs an auto-channel-selection on a radio. The radio should
already have been configured for ACS support.
Configures the self-healing offset (measured in dBm), for
regulatory compliance.
Note: The offset is based off the regulatory maximum
power for the specified channel ("show wireless regulatory"
displays the max power allowed).
Enables the Short GI value for both the 20 MHz and the 40
MHz channels for the 11n radio.