Ap-Detection - Motorola RFS Series Reference Manual

20-14 Motorola RF Switch CLI Reference Guide

20.1.7 ap-detection

Wireless Configuration Commands
Configures access port detection parameters
Supported in the following platforms:
• RFS7000
• RFS6000
Syntax
ap-detection [approved|enable|mu-assisted-scan|timeout]
ap-detection approved add <list-index> [<MAC>|any]
ap-detection enable
ap-detection mu-assisted-scan [enable|refresh <refresh-
period>]
ap-detection timeout [approved|unapproved] <timeout>
Parameters
approved add
<list-index>
[<MAC>|any]
enable
mu-assisted-scan
[enable|
refresh <refresh-period>]
Sets the approved access port list
• add <list-index> – Adds an entry to the approved access
port list at the index <list-index>.
• <MAC> – The a MAC address <MAC> in AA-BB-CC-DD-
EE-FF format.
• any– Assigns any MAC address.
Allows access ports to look for APs
Sets mobile unit assisted scanning configuration
• enable – Enables mobile unit assisted scanning
• refresh <refresh-period>> – Defines the period
<refresh-period> (300 – 86400) (in seconds) used by all
scan-capable mobile units are polled to scan for
neighboring access ports.