Class; Creating A Dhcp User Class - Motorola RFS Series Reference Manual

17-6 Motorola RF Switch CLI Reference Guide

17.1.3 class

DHCP Config Commands
Associates a DHCP class with a pool
This command is used in Step 4 of
The CLI prompt moves to a sub-instance
changes from
Refer to config-dhcp-class on page 17-7
Supported in the following platforms:
• RFS7000
• RFS6000
Syntax
class <class-name>
Parameters
class <class -name>
Example
RFSwitch(config-dhcp)#class RFS7000DHCPclass
RFSwitch(config-dhcpclass)#

17.1.3.1 Creating a DHCP User Class

Follow the steps below to create a DHCP User Class:
1. Create a DHCP class named
32 DHCP classes.
RFSwitch(config)#ip dhcp class RFS7000DHCPclass
RFSwitch(config-dhcpclass)#
2. Create a USER class named
switch supports a maximum of 8 users classes per DHCP class.
RFSwitch(config-dhcpclass)#option user-class MC800
RFSwitch(config-dhcpclass)#
(config-dhcp)# class
RFSwitchDHCPclass
MC800
Creating a DHCP User
(config-dhcp-class)
to
(config-dhcp-class)
for a
(config-dhcp-class)
Associates a class with a pool and enters the
DHCP pool class configuration mode
. The switch supports a maximum of
. The mode changes to
Class.
.The configuration mode
.
command summary.
(config-dhcpclass)
. The