Removing The Shipping Screw; Installing The Transparency Unit - Epson Expression 1600 User Manual

Removing the Shipping Screw

To prevent damage during shipping, a shipping screw is attached to the transparency
unit to secure its lamp assembly. You must remove this screw before using the
transparency unit.
1. Turn the transparency unit so the glass side faces up.
2. Use a Phillips head (cross
head) screwdriver to remove
the shipping screw from the
hole labeled
CLAMP
shown at right.
3. Install the screw in the
storage hole labeled
.
STOCK
Before transporting the scanner,
be sure to reinstall the shipping screw in the hole labeled
transportation lock at the back of the scanner to the

Installing the Transparency Unit

Follow these steps to install the transparency unit on the scanner.
1. Make sure the scanner is turned off. Then unplug the power cable from the
scanner.
2. Remove the document cover
by grasping the back of the
document cover as shown and
easing the cover up.
3. Make sure the document table
is clean and dust free.
, as
, and slide the
CLAMP
position.
LOCK
95