Installing The Automatic Document Feeder - Epson Expression 1600 User Manual

Installing the Automatic Document Feeder

Don't remove the protective foam block from the mounting hardware until you've
finished installing the automatic document feeder.
Because the automatic document feeder is heavy, you may want
to have someone help you with this procedure.
Follow the steps below to install the automatic document feeder on your scanner:
1. Make sure your scanner is turned
off and unplug the cables.
2. Remove your scanner's document
cover by grasping the back of
the cover as shown and easing the
cover up.
3. Make sure the document table is
clean and dust free.
4. Position the automatic
document feeder's mounting
slots over the two mounting
screws located at the back of
the scanner. Slide the
automatic document feeder
forward slightly until the two
holes in front of these slots
are aligned with the screw
holes at the back of the
scanner.
Don't remove the foam
block until you're done
installing the unit.
103