Removing The Shipping Screw; Installing The Transparency Unit - Epson Expression 1680 User Manual

Removing the Shipping Screw

To prevent damage during shipping, a shipping screw is attached to the transparency
unit to secure its lamp assembly. You must remove this screw before using the
transparency unit.
1. Turn the transparency unit so the glass side faces up.
2. Use a Phillips (cross
head) screwdriver to
remove the shipping
screw from the hole
labeled
CLAMP
shown at right.
3. Install the screw in the
storage hole labeled
.
STOCK
Caution: Before transporting the transparency unit, follow the procedures on
page 36 to protect it from damage.

Installing the Transparency Unit

1. Make sure the scanner is turned off.
2. Remove the document cover by
grasping the back of the document
cover and easing the cover up.
3. Make sure the document table is
clean and dust free.
4. Position the slots on the transparency
unit's mounting bracket over the
heads of the two mounting screws
located at the back of the scanner.
, as
Using Optional Equipment
21