Denon DVD-5910 Operating Instructions Manual page 84

ENGLISH
Symptom
An image is not projected with an
HDMI/DVI connection.
Picture and sound are interrupted with
HDMI/DVI connections
Remote control unit does not operate.
84
• Check the HDMI/DVI connection.(Check the status of the HDMI/DVI indicators.)
• Check whether the connected monitor equipment or other equipment supports HDCP.
(The DVD-5910 will not output a video signal unless the connected equipment supports
HDCP.)
• Check the settings of "HDMI/DVI SELECT".
• Check whether the output format of the DVD-5910 (HDMI/DVI FORMAT) matches the
input format of the connected equipment.
• Check whether the video output setting at "PURE DIRECT" is set to "VIDEO OUT : OFF"
or "ALL OFF".
• When the "HDMI/DVI FORMAT" setting is set to "AUTO", the picture or sound may be
interrupted when cables are connected or disconnected or depending on the conditions of
the connected device(s).
• Check that the batteries are inserted in the proper "<" and ">" directions.
• The batteries are dead. Replace them with new batteries.
• Point the remote control unit at the remote control sensor when operating it.
• Operate the remote control unit within a distance of 7 meters from the remote control
sensor.
• Remove the obstacle between the remote control unit and remote control sensor.
Check
ENGLISH
Page
23
19~21
56
19~21
50, 51
56
24
24
24
24
24