Denon DVD-5910 Operating Instructions Manual page 16

ENGLISH
(5) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See pages 40 ~ 44.)
• "DIGITAL OUTPUT" → "PCM"
"LPCM (44.1kHz/48kHz)" → "ON"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
DVD-5910
NOTE:
• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connections to record Super Audio CDs.
(6) Connecting to a Stereo Component
DVD-5910
NOTE:
• When connecting to a 2-channel audio stereo device using the "5.1ch AUDIO OUT", set "AUDIO CHANNEL" under "AUDIO
SETUP" on the "SETUP" to "2CH (SRS OFF)" or "2CH (SRS ON)" (see pages 40, 41.). For multi-channel sources, the signals
are down-mixed into two channels (analog).
(Only the front left and right channels are output for sources for which down-mixing is prohibited.)
16
B
Digital audio
input connector
(OPTICAL)
Optical fiber cable 75Ω/ohms pin-plug cable
(or)
(commercially available) (commercially available)
Stereo component
ENGLISH
8 9
Digital audio
input connector
(COAXIAL)