Connecting the Cisco VC 220 Camera
Verifying the Hardware Installation
STEP 3
Verifying the Hardware Installation
NOTE
VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide
Connect the PoE power injector to power.
PoE Power Injector
Non PoE Switch
After you install the Cisco VC 220 camera, check the Status LED to verify
connectivity. See
Parts of the Camera, page
It is suggested that you install the software (see
Network Camera Software, page
camera. After the software is installed, you will be able to use the web-based
configuration utility to see how the lens should be adjusted and how the camera
needs to be focused. See
for instructions on lens and focusing adjustments, and how to replace the dome
cover.
(optional)
26) before you replace the dome cover on the
Finalizing the Cisco VC 220 Hardware Setup, page 87
11.
Installing the Cisco VC 220
3
25