Applications > Recording; Recording; Recording Schedule; Destination - Cisco VC 220 Administration Manual

Configuring the Cisco VC 220 Network Camera Software
Applications > Recording
Applications > Recording
VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide
Recording shows a single item, Recording, which allows the configuration of the
recording name, status, schedule, stream source and destination of recording. To
record to a network storage server device, you must add the NSS device to the
Samba file server first. See
The camera allows a maximum of two recording entries.
Click Add to open up the Recording Setting page.

Recording

• Recording entry name—Enter a descriptive name for the recording setting.
• Enable this recording—Select this option to enable video recording.
• Priority—Select the relative importance of this recording setting. Choices
are high, normal, and low.
• Source—Select either Stream 1 or Stream 2 as the recording source.

Recording Schedule

• Recording Schedule—Specify the recording schedule and duration.
- Select the specific days that you would like recording to occur.
- Select when to record. Choices are Always, or a specific time period in
a 24-hour time format.

Destination

• Destination—Specify a storage destination for the recorded video files. A
network storage server must be configured before an entry appears. See
the Samba section on
• Capacity—Allows you to set up a quota. If you want the camera to keep
recording until all the space is used, choose Entire Free Space. Entire Free
Space allows recordings to takes up the entire disk free space, reserving a
default 100MB disk space. If you want to predefine a specific amount of
storage space for recording, choose Reserved Space. Reserved Space
allows recordings to take up everything except the defined reserve space.
Samba, page 65 for more information.
page 65.
6
73