Applications > Events; Configuring Media Settings; Media; Media Type - Cisco VC 220 Administration Manual

Configuring the Cisco VC 220 Network Camera Software
Applications > Events
Applications > Events
NOTE
VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide
values allow for easier motion detection. Set your percentage to low and
the chances are greater that motion will be detected.
An event can be triggered by many sources, such as motion detection or external
digital input devices. When an event is triggered, you can specify what kind of
action will be performed. For example, you can configure the Cisco VC 220
network camera to send buffered images to an FTP server and to send email
notifications when motion is detected.
A maximum of three events can be configured.
Configure motion detection events in the following order:
1. Set up your servers to specify event delivery; see
page 63.
2. Configure your media; see
3. Configure your event settings, such as triggers; see
Settings, page 70.

Configuring Media Settings

Media

• Media Name—Enter a descriptive name for the media setting.

Media Type

• Snapshot—Sends snapshots when a trigger is activated.
- Source—Choices are Stream 1 or Stream 2.
- Send # pre-event images (0-7)—Specify how many images to capture
before a trigger is activated. Up to seven images can be captured. The
default is 1 image.
- Send # post-event images (0-7)—Specify how many images to
capture after a trigger is activated. Up to seven images can be captured.
For example, if both the Send pre-event images and Send post-event
images are set to seven, a total of 15 images are captured after a trigger
is activated. The default is 1 image.
Configuring Media Settings, page
Applications > Servers,
69.
Configuring Event
6
69