Cisco VC 220 Administration Manual page 13

Getting to Know the Cisco VC 220 Network Camera
Parts of the Camera
VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide
Use a bent paperclip to press the Reset button. The Reset
Recessed
Reset Button button has two functions:
Restart—Press and hold the Reset button for less than five
seconds to reset the camera.
Restore Factory Defaults—Press and hold the Reset button
for 10 seconds to restore factory defaults.
NOTE
220 camera or if you restore the camera's default settings. We
recommend that you change the time zone and daylight
saving period first, and then set the date and time. Set the
date and time by either syncing to a local PC, setting the date
and time manually, or connecting to an NTP server. See
Administration > Time Settings, page 80
information.
Power Cord Included. Connects your Cisco VC 220 camera to 12 V
Port power (1 Amp) when not using PoE.
Ethernet RJ45 Connects your Cisco VC 220 camera to a Power over
Port Ethernet (PoE) switch or router, or to a PoE power injector (not
included) for connection to a non-PoE switch or router. The
LEDs surrounding the Ethernet port indicate the following
status:
Green—Indicates network and data activity. Light should be
steady when camera is on and flashing when data is
transmitted or received.
Amber—Indicates PoE. Should be steady when using PoE.
Set the date and time when you first install the VC
2
for more
13