Applications > Servers; Simple Mail Transfer Protocol (Smtp) - Cisco VC 220 Administration Manual

Configuring the Cisco VC 220 Network Camera Software
Applications > Servers
Applications > Servers
VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide
Use the Applications > Servers page to set how alerts are to be reported. When
you complete each configuration, click Test to test your settings or Save to save
the settings; otherwise click Cancel to discard the changes.
Click a tab to choose the type of server:
•

Simple Mail Transfer Protocol (SMTP)

• File Transfer Protocol (FTP)
• Samba
• HTTP
• Instant Message (IM Server)
Simple Mail Transfer Protocol (SMTP)
Complete the Simple Mail Transfer Protocol (SMTP) server section if you want an
alert sent to you by email when motion detection is triggered.
• Server name—Enter a descriptive name for the server.
• Sender email address—Enter the sender's email address.
• Recipient email address—Enter the recipient's email address; i.e., to whom
the media should be sent when a trigger is activated.
• Server address—Enter the domain name or IP address of the email server.
• Username—Enter the username of the email account.
• Password—Enter the password of the email account.
• Server port—Defaults to 25 for the SMTP port setting.
• SSL Encryption—Check to enable. May be required for data security by
your email provider. By selecting SSL encryption, the default port changes
from 25 to 465.
To verify that the email settings are correctly configured, click Test. The result is
shown in a pop-up window.
If successful, you will also receive an email indicating the result. The email will
display the sender that you specified and will have a subject line similar to
"Notification: Result of Server Test of Your IP Camera."
6
63