Verifying The Hardware Installation; Getting Started With The Configuration - Cisco Small Business VC240 Quick Start Manual

Verifying the Hardware Installation

5
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Verify that the Status LED is flashing green as described in the
Panel" section on page
If you need help resolving a problem, visit the Cisco Small Business
N
OTE
Support Community at www.cisco.com/go/smallbizsupport. For
technical documentation and other links, see the
Here" section on page

Getting Started with the Configuration

6
Before you begin to use the Configuration Utility, make sure that you have a
computer that meets the following requirements:
• Windows XP, Windows Vista, or Windows 7.
• Internet Explorer (version 6 or higher)
You get limited functionality if you use Firefox or Safari.
N
OTE
To locate and access the camera, follow these steps:
Make sure your computer is on the same network as the camera.
S 1
TEP
If there is no DHCP server present in the network, the camera
defaults to the 192. 1 68. 1 .99 IP address. In this case, make sure that
your computer is on the 192. 1 68. 1 network.
Insert the Cisco VC240 Setup CD into your computer's CD-ROM
S 2
TEP
drive. If the CD doesn't run automatically, go to My Computer and
double-click the CD-ROM drive to launch the application.
Choose a language from the drop-down menu then click Next.
S 3
TEP
When the Setup screen appears, click Start.
S 4
TEP
Follow the Setup Wizard instructions to locate the Cisco VC240
S 5
TEP
camera on your network.
After the Setup Wizard locates the camera, the Device Selector
window appears.
Select the entry with the same MAC address or serial number as
S 6
TEP
your camera.
Cisco VC 240 Network Camera Quick Start Guide
3.
19.
"Where to Go From
"Front
15