Cisco VC 220 Administration Manual page 22

Connecting the Cisco VC 220 Camera
Installing the Cisco VC 220 Camera
STEP 5
STEP 6
NOTE
VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide
Hammer the supplied plastic anchors into the holes.
Align the two holes on each side of the camera base with the two plastic anchors
on the wall, insert the supplied screws to corresponding holes, and secure them
with a screwdriver.
Your Cisco VC 220 camera is now ready for network setup.
The wall mount screws come with anchors that can be used for drywall or
concrete. The screw size is a metric M4 with a length of 31.75 mm. The anchor is
the same length and internal diameter to accept the screw.
For non-metric countries, the equivalent screw size is #8 x 1 ¼ inch. The anchor
size is #8-#10 with a length of 1 ¼ inch.
Alignment template
3
22