Cisco VC 220 Administration Manual page 88

Finalizing the Cisco VC 220 Hardware Setup
Adjusting the Lens
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide
To adjust the viewing angle:
Loosen the pan screw and turn the lens module left and right. Upon completion,
tighten the pan screw.
Loosen the tilt screws on both sides of the camera and then turn the lens module
up and down to point the lens at the area of interest. Upon completion, tighten the
tilt screws.
Loosen the image adjustment screw and then turn the lens to adjust the image
orientation. Upon completion, tighten the image adjustment screw.
Rotate the screw
Turn the lens
Loosen
Loosen the zoom controller to adjust the zoom factor from Wide to Telephoto.
Upon completion, tighten the zoom controller.
Loosen the focus controller to adjust the focus range from Near to Infinity. Upon
completion, tighten the focus controller.
1
Tighten
Loosen
Tighten
Zoom
Focus
Loosen
2
Tighten
W
7
Tighten
Loosen
3
T
N
88