Attaching The Dome Cover - Cisco VC 220 Administration Manual

Dome wdr day/night poe network camera

Hide thumbs Also See for VC 220:

Table of Contents

Finalizing the Cisco VC 220 Hardware Setup

Attaching the Dome Cover

STEP 1

STEP 2

STEP 3

STEP 4

STEP 5

VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide

The supplied screwdriver is exclusively designed to match the dome screws. In

case you need to adjust the camera at a later time, do not discard the screwdriver.

Route all the cables through the base channel under the camera.

TIP

Use the two L-shaped audio cables when you route the cables to prevent

having to remove a tab.

(Optional) Remove the tab (or tabs) from the dome cover to accommodate the

cables. To avoid injury, place the pliers in the middle of the tab and pull outward.

Attach the dome cover to your Cisco VC 220 camera.

Secure the two dome screws with a screwdriver.

Ensure all parts of your Cisco VC 220 camera are securely installed

You are now ready to start using your Cisco VC 220 camera.

Table of Contents