Quick Reference Guide; Preparation; Battery Installation - Icom IC-R6 Instruction Manual

Preparation

D Battery installation
q Remove the batter y
cover from the receiver.
w Install 2 R6(AA) size
Ni-MH or alkaline cell
batteries.
• Be sure to observe the
correct polarity.
• Charge the Ni-MH bat-
teries before use. (See
p.III for charging instruc-
tions.)
Keep the battery terminals clean. It's a good idea to clean
the battery terminals once a week.
D Belt clip
Conveniently attaches to
your belt.
Slide the belt clip into the
plastic loop on the back of
the receiver.

QUICK REFERENCE GUIDE

D Antenna
Insert the antenna connector into
the antenna base and tighten the
antenna screw.
• NEVER carry the receiver by
holding only the antenna.
Latch
• When the jack is not in use,
keep the jack cover attached
to protect the connectors from
dust and moisture.
For your information
Third-party antennas may increase receiver performance.
An optional AD-92SMA
available to connect an antenna with a BNC connector.
D Handstrap
To facilitate carrying the receiver,
slide the hand strap through the
loop on the top of the belt clip.
ANTENNA CONNECTOR ADAPTER
is
I