8
TONE SQUELCH AND POCKET BEEP
Tone/DTCS squelch operation
The tone or DTCS squelch opens only when receiving a
signal with the same pre-programmed subaudible tone or
DTCS code, respectively. You can silently wait for the speci-
fied signal using the same tone.
q Set a desired frequency in the FM mode.
w Hold down [SET](TS) for 1 second to enter the Set mode.
e Rotate [DIAL] to select the "EXPAND" item.
r While holding down [FUNC], rotate [DIAL] to turn the
Expand set mode ON.
t Rotate [DIAL] to select the "TSQL" item.
y While holding down [FUNC], rotate [DIAL] to select a
desired subaudible tone setting from "TSQLS," "TSQL,"
"DTCS," "DTCSS," "TSQL (reverse)," "DTCS (reverse)"
or "OFF."
Tone squelch with pocket beep
Tone squelch
DTCS squelch with pocket beep
39
DTCS squelch
Tone squelch (reverse)
DTCS squelch (reverse)
u Push [SET](TS) to exit the Set mode.
• One of "S T SQL," T SQL," "SDTCS," "DTCS," "T SQL-R"
or "DTCS -R" appears according to the tone selection in step y.
Tone squelch with pocket beep
Tone squelch
DTCS squelch with pocket beep
i When a signal with the matched tone is received, the
squelch opens and the receiver emits audio.
When pocket beep function is activated, the receiver also
emits beep tones and blinks "S."
• Beep tones sound and "S" blinks for 30 seconds.
o Push [FUNC] to stop the beeps and blinking manually.
• "S" disappears and the pocket beep function is deactivated.
!0 To cancel the tone squelch or DTCS, select "OFF" with the
"TSQL" item in the Expand set mode, as described in step
y.
DTCS squelch
Tone squelch (reverse)
DTCS squelch (reverse)