Quick Reference Guide; Preparation - Icom IC-R6 Instruction Manual

■ Preparation

D Battery installation
q Remove the batter y
cover from the receiver.
w Install two AA (LR6)
size Ni-MH or alkaline
cell batteries.
• Be sure to observe the
correct polarity.
• Charge the Ni-MH bat-
teries before use. (See
p a g e I I fo r c h a r g i n g
instructions.)
Keep the battery terminals clean. It's a good idea to clean
the battery terminals once a week.
D Belt clip
Conveniently attaches to your
belt.
To attach the belt clip:
Slide the belt clip into the plastic
loop on the back of the receiver.
To detach the belt clip:
Hold down the tab (q), and slide
the belt clip in the direction of the
arrow (w).

QUICK REFERENCE GUIDE

Latch
w
q
D Antenna
Insert the antenna connector into
the antenna base and tighten the
antenna screw.
• NEVER carry the receiver by
holding only the antenna.
• When the jack is not in use,
keep the jack cover attached
to protect the connectors from
dust and moisture.
✔ For your information
Third-party antennas may increase receiver performance.
An optional AD-92SMA
antenna connector adapter
available to connect an antenna with a BNC connector.
D Handstrap
To facilitate carrying the receiver,
slide the hand strap through the
loop on the top of the belt clip.
is
I