Pocket Beep And Tone Squelch; Pocket Beep Operation - Icom IC-R1500 Instruction Manual

8

POCKET BEEP AND TONE SQUELCH

■ Pocket beep operation

This function uses subaudible tones for calling and can be
used as a "common pager" to inform you that someone has
called while you were away from the receiver.
D Waiting for a call from a specific station
q Set the operating frequency in FM mode.
w Push [SET•LOCK] to enter set mode.
[SET•LOCK]
e Push [SET•LOCK] or [S.MW•MW] several times until "Ct"
(when selecting the tone squelch frequency) or "Dt" (when
selecting the DTCS code squelch) appears.
Tone squelch frequency setting
r Rotate [DIAL] to select the desired tone frequency or
DTCS code.
[DIAL]
31
DTCS code setting
t When operating the pocket beep function with DTCS code
squelch, push [SET•LOCK] once then rotate [DIAL] to se-
lect the DTCS polarity.
DTCS polarity setting
y Push [TS•MODE] or any switch below the display to exit
set mode.
u Push and hold [MONI•T/T-SCAN] for 1 sec to enter tone
squelch selection mode, then rotate [DIAL] until "S "
or " S" appears to turn the pocket beep function ON
with tone squelch or DTCS squelch, respectively.
[DIAL] [MONI•T/T-SCAN]
Appears when the pocket beep
with tone squelch is turend ON.
Appears when the pocket beep
with DTCS squelch is turned ON.