Table of Contents
Advertisement
I Pocket beep operation
This function uses subaudible tones for calling and can be
used as a "common pager" to inform you that someone has
called while you were away from the receiver.
D Waiting for a call from a specific station
q Set the operating frequency in FM mode.
w Push [SET•LOCK] to enter set mode.
e Push [SET•LOCK] or [S.MW•MW] several times until "Ct"
(when selecting the tone squelch frequency) or "Dt" (when
selecting the DTCS code squelch) appears.
r Rotate [DIAL] to select the desired tone frequency or
DTCS code.
t When operating the pocket beep function with DTCS code
squelch, push [SET•LOCK] once then rotate [DIAL] to se-
lect the DTCS polarity.
POCKET BEEP AND TONE SQUELCH
y Push [TS•MODE] to exit set mode.
u Push [MONI•T/T-SCAN] for 1 sec and rotate [DIAL] until
S" appears to turn the pocket beep
"S
" or "
function ON with tone/DTCS squelch, respectively.
i When a signal with the matched tone is received, the re-
ceiver emits beep tones and blinks "S."
• Beep tones sound for 30 sec. and "S" blinks. To stop the
beeps and blinking manually, push any key. When the beep
tones are not stopped manually, "S" continues blinking until
[TONE•T-SCAN] is pushed (see step o).
o Push [TONE•T-SCAN] several times until "T SQL" or
"DTCS" disappears to cancel the tone squelch or DTCS
squelch function.
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
26
Advertisement
Table of Contents
