12.6 Removal of the rear panel gives access to:
The rear brush
-
The drive belt
-
The drum
-
The duct
-
-
The duct rollers
-
The front and rear seals
12.6.1 Rear brush (conductimetric sensor)
•
Remove the screw which secures the drum
spindle cover.
•
Rotate the drum cover pin until it is released
from the anchor in the lower section.
•
The brush is located inside the protective
cover.
12.6.2 Rear panel
•
Remove the work top.
•
Unscrew the screw which secures the canister support.
•
Remove the left-hand and right-hand side panels.
•
Remove the back air cover.
•
Remove the rear brush (i).
•
Unscrew the screw which secures the bush (j).
•
Remove the Benzing ring and the spacing washer (k).
•
Disconnect the terminal block from the heater unit.
•
Disconnect connectors on the main terminal block.
•
Unscrew the screws which secure the rear panel to the
crossbars and to the base (a screw beneath the heater
unit secures the rear panel to the base).
12.6.3 Drive belt
•
Remove the work top.
•
Remove the side panels.
•
Remove the rear panel.
•
Remove the rear duct cover.
12.6.4 Drum
•
Remove the work top.
•
Remove the side panels.
•
Remove the rear panel.
•
Extract the drum and the belt.
SOI/ADL
52/57
k
j
i
599 38 46-21