12.2 Work top
The following components can be accessed from the
work top:
-
Front brush
Control panel
-
Control panel support
-
Electronic main board
-
CRM electronic board
-
•
To remove the work top, first remove the screws
which secure the top to the rear edge of the
appliance.
•
Slide the top towards the rear.
12.2.1 Front brush of conductimetric sensor
•
Remove the connector.
•
Extract the brush from the seat fitted to the duct.
12.2.2 Canister
Extract the canister from the appliance.
SOI/ADL
40/57
599 38 46-21